The following list of documents and videos are intended to assist with installation of your 15L Slant-PRO®. The items are presented in the recommended order of installation. Tormach strongly urges customers to follow this sequence when installing your equipment in order to avoid installation conflicts. Please note that some of the installation instructions/videos may not be applicable for your particular set of equipment accessories.

Tormach 15L Slant-PRO CNC Lathe Unboxing

May 22, 2014 - Tormach 15L Slant-PRO CNC Lathe: An overview of the installation and setup for the Tormach 15L Slant-PRO CNC Lathe. Topics include: 1. Initial Uncrating 2. Coolant System...

Tormach 15L Slant-PRO Lathe Lifting Kit

May 14, 2014 - Tormach Lathe Lifting Kit (PN 33269): Lifting Kit for the Tormach 15L Slant-PRO CNC Lathe is used to safely remove the lathe from the shipping pallet without the need for...

How to Install and Use a D1 Lathe Chuck – Tormach CNC

May 15, 2014 - 3-Jaw Reversible 6"Lathe Chuck 4-Jaw Independent Reversible 6" Lathe Chuck- This video demonstrates how to properly install a D1-4 Lathe Chuck on...

How to Adjust the 5C Collet- Closer – Tormach CNC

July 21, 2014 - Tormach 15L Slant-PRO CNC Lathe: 5C Collet Closer Option:This video demonstrates the proper technique on how to set the tension on the manual 5C...

Tormach 15L Slant-PRO Quick Change Overview

June 18, 2014 - Tormach 15L Slant-PRO CNC Lathe: Quick Change Lathe Tool Holders: This video demonstrates how to install and work with the quick change tool post....

How to Install Turret Boring Bar Holders on the Tormach 15L Slant-PRO Lathe

March 10, 2015 - Boring Bar Holder for Turret: In this video, Mike Corliss, uses a carbide endmill to machine out turret boring bar holders on the Tormach 15L Slant-Pro Lathe. The boring...

Tormach 15L Slant-PRO CNC Lathe; Setting Up the Tailstock

September 22, 2014 - Tormach 15L Slant-PRO CNC Lathe: This video explains how to install the Tailstock onto the Slant-PRO Lathe. Check out our website for more information on the tailstock.

Cutting Your First Part on a Tormach Lathe

March 31, 2016 - Tormach Control Engineer, Daniel Rogge, walks through cutting your first part on a Tormach 15L Slant-PRO Lathe found in chapter 4 of the operator's manual. Learn more about the 15L Slant-PRO...