35927-SET - PCNC 440 Power Drawbar
Product Info
35927-SET - PCNC 440 Power Drawbar
PN: 35927-SET
Shipping Weight: 19.5 lbs.
Stock: In Stock
Eliminate the need to hand-tighten your drawbar and install this Power Draw Bar on your PCNC 440 for lightning-fast tool changes with the push of a button.
The power drawbar is designed for use with the Tormach Tooling System (TTS), but easily pivots away to allow manual tightening of the drawbar if necessary for conventional R8 tooling.
- Requires 90 psi Air Supply (FRL unit recommended)
- Designed for use with Tormach Tooling System (TTS) toolholders
- Multi-stack air-over-air pneumatic cylinder ram actuation
- Does not load the Spindle Bearings
- Easily Pivots for Manual drawbar tightening for R8 tooling
The Power Drawbar kit includes pneumatic cylinder assembly stack, drawbar, pneumatic push-button box, and all necessary pneumatic tubing.
For Series 3 Mills and earlier PN 31991 is required for connection to compressor
Product & Recommended Accessories