SET TOOL TABLE (G10 L10)

SET TOOL TABLE (G10 L10)

To change the tool table entry for tool P so that if the tool offset is reloaded with the mill in its current position and with the current G5x and G92 offsets active, program: G10 L10 P- Z~ R~ I~ J~ Q~

  • P~ is the tool number
  • R~ is the radius of tool

The current coordinates for the given axes become the given values. The axes that are not specified in the G10 L10 command are not changed. This could be useful with a probe move (G38).

TROUBLESHOOTING

It’s an error if:

  • Cutter Compensation is on
  • The P number is unspecified
  • The P number is not a valid tool number from the tool table
  • The P number is 0
SET TOOL TABLE (G10 L10)