RETURN TO PREDEFINED POSITION (G30 AND G30.1)

RETURN TO PREDEFINED POSITION (G30 AND G30.1)

G30 uses the values stored in parameters 5181 and 5183 as the X and Z final point to move to. The parameter values are absolute mill coordinates in the native machine units of inches.

To make a rapid traverse move from the current position to the absolute position of the values in parameters, program: G30

To make a rapid traverse move to the position specified by axes including any offsets, then make a rapid traverse move to the absolute position of the values in parameters 5181 and/or 5183, program: G30 X~ Z~

Any axis not specified won’t move.

To store the current absolute position into parameters 5181-5183, program: G30.1

TROUBLESHOOTING

It’s an error if:

  • Cutter Compensation is turned on
RETURN TO PREDEFINED POSITION (G30 AND G30.1)